6/25/2023 0 Comments Mt mograph motion 2 wont installInspect and replace the quick exhaust if needed. If the quick exhaust is not working properly it may cause the tool to drop slightly or be miss positioned during the tool change. The TRP quick exhaust is not functioning properly Refer to VMC - Servo-Driven Side-Mount Tool Changer - Grid Offset and Tool Changer Offset. Set the correct values for the Parameters 481 and 487. The values of Parameters 481 or 487 are incorrect in a machine with a servo-driven side-mount tool changer. Move the obstructions or set a safe tool change position.įind the cause of the spindle orientation error. The cambox drive belt is worn or damaged.Īlarm 628/673 ATC/TA ARM POSITIONING ERROR Pressing after updating software generates a 2066 alarm Rotate the arm in recovery mode and test the sensors. One or more of the proximity sensors or cables on the cambox have a bad connection or is damaged. VMC, HMC - Side-Mount Tool Changer - Manual Recovery Video - Tool Changer Recovery - Side Mount Tool Changer (SMTC) The tool changer arm is not at the origin position when the machine is powered on, or it was not recovered correctly. Alarm 2066 TOOL CHANGER HOME POSITION FAULT
0 Comments
Leave a Reply. |